Chapter 1. General Description. Technical Characteristics - GALAGAR GAR CUT 2500 Manual De Instrucciones

CHAPTER 1. GENERAL DESCRIPTION. TECHNICAL CHARACTERISTICS.
The cutting function of the GAR CUT (V. Industrial Electrónica) machines is carried out by electric plasma
blown with compressed air. They can cut all kinds of electricity conductor material: Steel, stainless steel,
aluminium, brass, etc. The control of the plasma arc power in these equipments is conducted electronically.
The adjustment of the cutting capacity is continuous and conducted by a potentiometer. This equipment has an
antipollution system that means that the fan will only start up when necessary.
A Euro-connector is located on the front of the equipment which enable you a quick connection of welding
torch supplied. The following are supplied with the equipment:
Cutting torch P-150, CE security system, protection goggles and connection earth cable.
This equipment has protection against: overheating, lack of pressure in pneumatic circuit, overloads in the
control circuit, contacts with dangerous voltages during the replacement of torch head components and
protection against cutting without earth return.
TECHNICAL CHARACTERISTICS.
Supply voltage (U
1
Maximum primary intensity (I
Primary effective intensity (I
Plasmagen gas
Operating air pressure
Flowrate
Rated cutting intensity
Power range adjustment
Cutting thickness up to (Ordinary steel)
Ventilation
Weight
GAR CUT (V. INDUSTRIAL). Instructions Manual
Maximum cutting thicknesses. Orientation data.
MAXIMUM RECOMMENDED
MATERIAL
CUT
2500
SOFT STEEL 20 mm
STAINLESS STEEL 20 mm
ALUMINIUM 16 mm
For use of any other accessory check with the manufacturer.
Main technical characteristics. (EN 60974)
–3Ph 50/60 Hz)
)
1max
)
1eff
RUEDA MOVIL
LIMIT THICKNESS
CUT CUT CUT
4000 5000 2500
35 mm 35 mm 25 mm
35 mm 35 mm 25 mm
25 mm 25 mm 20 mm
GAR CUT 2500
Ref. 454.00.000
230/400 V
51/ 30 A
40/ 23 A
AIR
5,5-6 bar
175-210 l/min
55 A (100%)
20 ÷ 75 A (60%)
25 mm
FORCED
Antipollution system Antipollution system
135 KG.
RUEDA FIJA
CUT CUT
4000 5000
40 mm 50 mm
40 mm 50 mm
30 mm 35 mm
GAR CUT 4000 GAR CUT 5000
Ref. 456.00.000 Ref. 456.84.000
230/400 V 230/400 V
84/ 50 A 97/ 56 A
53/ 32 A 53/ 32 A
AIR
5,5-6 bar 5,5-6 bar
175-210 l/min 175-210 l/min
80 A (100%) 80 A (100%)
20 ÷130 A (40%) 20 ÷150 A (30%)
40 mm
FORCED FORCED
Antipollution system
175 KG.
IP 21
CL. H (180º C)
15
AIR
50 mm
175 KG.