Remington I-LIGHT REVEAL Guía De Uso Y Cuidado página 11

ENGLISH
• After reaching level 3, pressing the Energy Level Button again will reset back to energy level 1.
• The i-Light REVEAL is equipped with 3 energy levels. Level 1 (1 bar) is the lowest and level 3 (3 bars)
is the highest.
, TIP: For the most effective results, always use the highest energy level that does not cause discomfort
on the skin.
, Test the i-Light REVEAL on your skin
• Before your first full treatment, test the i-Light REVEAL device on a small patch of skin and wait 24
hours to ensure there are no adverse reactions.
• Start at energy level 1 and flash once.
Flash the skin by placing the flash window firmly against your skin. You will hear a 'beep beep' and the
skin tone sensor should show a solid green light. Press the flash button to deliver a flash. Fig. 12
, TIP: It is helpful to use a mirror to see the skin tone sensor. If the reflected light is unpleasant, you may
wish to close your eyes before each flash.
• Mild to moderate discomfort is normal. If a flash delivered at Energy Level 1 feels tolerable, increase to
Energy Level 2. Move the device to a different spot and flash the i-Light REVEAL one more time.
Repeat this process until you find the setting that feels right for you.
• Wait 24 hours and then look at the test area. If the skin appears normal, proceed with your first full
treatment at that the energy level you determined is right for you.
, NOTE: You must test the device on each area of the face or body you wish to treat.
, Treat desired area(s) with the i-Light device
, Prepare your skin for treatment
1. Ensure the area to be treated is clean and free from oils, deodorants, perfume, make up, lotions and
creams. Shave or trim the hair from the area to be treated, and ensure the skin is clean and dry. If
trimming; the hair must be trimmed to less than 0.5mm. Fig. 13
Fig. 12
Fig. 13
11