Vaillant geoTHERM VWS 61/2 Instrucciones De Uso página 51

Display shown
Mon. 21.04.08
Current flow temp.
CH pressure
Brine pressure
Heating only comp.
Warning message
Warning message
Table 5.1 Settable parameters in the operator level (ctnd.)
Operating Manual geoTHERM VWS/VWW 0020051547_02
Description
Energy input display
Shows the energy extracted from the environment for each of the
12 months of the current year (black bar). White-filled bars represent
the future months of the year; the height of the bar corresponds to
the yield for the month in the previous year (comparison possible). On
commissioning, the height of the bars is zero for all months, as no in-
formation is available yet.
The scaling (in the example, 4000 kWh) adapts automatically to the
month's highest value.
Top right the total of the environmental yield since commissioning is
displayed (in the example: 13628 kWh).
Day, date, time as well as flow temperature, heating system pressure
16:49 1
and heat source pressure are displayed.
28 °C
Current flow temp: Current flow temperature in the unit.
1.2 bar
Heating system pressure: Pressure sensor heating circuit.
1.4 bar
Pressure heat source: Pressure of the heat source (pressure sensor,
heat source circuit, brine pressure)
Heating only comp.: this status message provides information on the
current operating status.
The following are possible:
Heating only comp.
Heating comp & ZH
CH: ZH only
CH:Comp&aux off
WW:Comp&aux off
WW: Comp only
WW: ZH only
Peak Rate: WW
Peak Rate: Stand-by
Acceleration mode
Frost prot. Heating
Frost prot. Cylind.
Legionella protect.
Automatic pump spin
Floor drying
Venting mode
Fault shutdown: heating
Error shutdown: heating
Fault shutdown: WW
Error shutdown: WW
Malfunction
Blocking error
Operation interlock
CH Comp overrun
WW Comp overrun
Cooling & WW
C-H return too high
Under critical operating conditions a warning message is displayed in
both lower display lines. These lines are empty when the operating
conditions are normal.
Operation 5
GB 17