Equipment And Functional Description; Functional Principle; Operation Mode Of The Coolant Circuit - Vaillant geoTHERM VWS 61/2 Instrucciones De Uso

4 Equipment and functional description

4 Equipment and functional
description
4.1

Functional principle

Heat pump systems consist of separate circuits in which
fluids or gases transport the heat from the heat source
to the heating system. As these circuits work with dif-
fering media (brine/water, coolant and heating water),
they are coupled with one another by means of heat ex-
changers. In these heat exchangers, heat passes from a
medium at higher temperature to a medium at lower
temperature.
The Vaillant geoTHERM heat pump uses geothermal en-
ergy as its heat source.
Fig. 4.1 Using a geothermal heat source
8
1/4 Electrical energy
3/4 Environmental energy 4/4 Heating energy
Cold water
Heating system
Auxiliary
heating
Diverter valve
Heating water pump
3
Condenser
Expansion valve
4
Evaporator
Brine pump
Heat source
Fig. 4.2 Mode of operation of the heat pump
The system consists of separate circuits which are cou-
pled with one another by means of heat exchangers.
These circuits are:
- The heat source circuit, by means of which the energy
from the heat source is transported to the coolant cir-
cuit.
- The coolant circuit, from which heat is passed to the
heating water circuit by means of evaporation, com-
pression, liquefaction and expansion.
- The heating water circuit, which supplies the heating
and the hot water generator for the domestic hot
water cylinder.
4.2

Operation mode of the coolant circuit

The coolant circuit is connected by means of the evapo-
rator (1) to the geothermal heat source, from which it
extracts thermal energy. At the same time, the physical
state of the coolant changes; it evaporates. The coolant
circuit is connected by means of the condenser (3) to
the heating system, to which it releases the heat again.
In so doing, the coolant becomes liquid again; it con-
denses.
As thermal energy can only pass from a body at a high-
er temperature to a body at a lower temperature, the
coolant in the evaporator must have a lower tempera-
ture than the geothermal heat source. On the other
hand, the temperature of the coolant in the condenser
must be higher than that of the heating water in order
to be able to release the heat to it.
Operating Manual geoTHERM VWS/VWW 0020051547_02
Hot water
Domestic hot
water cylinder
Heating water circuit
2
Coolant circuit
Compressor
1
Heat source circuit