Initial Operation - Klarstein Delaware Manual De Instrucciones

EN
24

INITIAL OPERATION

Before first Use
• Before use, remove all packing materials, including bottom cushions, foam pads
and tapes inside of the refrigerator. Tear off the protective film on the doors and the
refrigerator body.
• Keep away from heat and avoid direct sunlight. Do not place the unit in moist or
watery places to prevent rust or reduction of insulating effect.
• Do not spray or wash the refrigerator. Do not put the refrigerator in moist places
easy to be splashed with water so as not to affect the electrical insulation properties
of the refrigerator.
• The refrigerator should be placed in a well-ventilated location where the floor is flat
and sturdy. To level the unit adjust the two leveling feet at the front of the unit. If the
unit is not level, the magnetic door may not close properly.
• The top space of the refrigerator shall be greater than 30 cm, and The refrigerator
should be placed against a wall with a free distance more than 10 cm to facilitate
heat dissipation. Keep at least 5 cm gap at two sides.
• Before initial start, keep the refrigerator still for half an hour before connecting it to
power supply.
• Before putting any fresh or frozen foods, the refrigerator shall have run for
2-3 hours, or for above 4 hours in summer when the ambient temperature is high.
• Spare enough space for convenient opening of the doors and drawers.
Location and ambient temperature
Install the unit in a place where the ambient temperature matches the climatic class of the
unit.
Climate class
SN
N
ST
T
Room temperature
+10 °C - +32 °C
+16 °C - +32 °C
+16 °C - +38 °C
+16 °C - +43 °C