Duct Fittings; Installing Preparation - ELICA EPT436SS Guía De Instalación, Uso Y Mantenimiento

electric cooktop/range.
doors, or it can be installed for recirculating operation

Duct Fittings

Duct pieces
6" Round,
straight
3¼"x10"
Rect.,
straight
6" Round,
90° elbow
6" Round,
45° elbow
3¼" x 10"
Rect. 90°
elbow
3¼" x 10"
Rect. 45°
elbow
3¼" x 10"
Rect. 90°
6" round to
3¼" x 10"
rect.
transition
Installation height
-
Equivalent number Total
lenght x used =
1 Ft. x ( ) = Ft.
1 Ft. x ( ) = Ft.
15 Ft. x ( ) = Ft.
8 Ft. x ( ) = Ft.
11 Ft. x ( ) = Ft.
6 Ft. x ( ) = Ft.
24 Ft. x ( ) = Ft.
1 Ft. x ( ) = Ft.
range. It can not be installed over any professional
cooktop / range.

Installing preparation

Advance planning
• Determine the exact location of the vent hood.
• Plan the route for venting exhaust to the outdoors.
• Use the shortest and straightest duct route possible. For
satisfactory performance duct run should not exceed 100'
•
permissible length for duct runs to the outdoors.
• Install a wall cap with damper or roof cap at the exterior
needed in advance.
•
Wall framing for adequate support
•
must be secure to vertical studs in the wall, or to a
•
work and electrical service.
• Installation will be easier if the vent hood is installed
before the cook-top and countertop are installed.
Duct pieces
3¼" x 10"
Rect.to
6" round
transition
6" round to
3¼" x 10"
rect.
transition
90° elbow
3¼" x 10"
Rect.to
6" round
transition
90° elbow
6" Round
wall cap
with damper
3¼" x 10"
Rect.
wall cap
with damper
7" - 10"
Round,
roof cap
DUCT FITTINGS:
Use this chart to compute maximum
permissible lenghts for duct runs to outdoors.
lenghts!
6
Equivalent number Total
lenght x used =
8 Ft. x ( ) = Ft.
16 Ft. x ( ) = Ft.
17 Ft. x ( ) = Ft.
30 Ft. x ( ) = Ft.
30 Ft. x ( ) = Ft.
26 Ft. x ( ) = Ft.
Total Duct Run