SOMFY Sunilus io Guia De Instalacion página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3.3. Motor/tube assembly
Slide the motor into the roller tube. For smooth roller
1)
tubes, position the cut notch on the crown.
For safety reason, fix the roller tube to the drive wheel
2)
with 4 self-tapping screws with a diameter of 5 mm or 4
steel pop rivets with a diameter of 4.8 mm located:
at least 5 mm from the far end of the drive wheel:
-
L1 - 5, and
no more than 15 mm from the far end of the drive wheel:
-
L1 - 15.
The screws or pop rivets must only be attached to the
drive wheel and not to the motor.
3.4. fitting the tube-motor assembly
Fit the tube/motor assembly to the end bracket (C).
1)
Fit the tube/motor assembly to the motor bracket (D).
2)
Depending on the type of supports fit the stop ring (E)
3)
[For the motors >= 85 Nm absolutely use the locking stop
ring (F)].
4. WIRING
Always make a loop in the power supply cable to prevent
water entering the motor!
Cut the power supply off.
-
Connect the motor according to the information in the
-
table below:
230 V ~ 50 Hz
1
Brown
Live (P)
2
Blue
Neutral (N)
3
Yellow/Green
Earth ( )
Copyright © 2010 Somfy SAS. All rights reserved.
Motor cable
Sunilus io / Sunilus screen io
1
2
15 mm
L1
1
2
D
3
E
OFF
3 x 0,75 mm
1
230 V
2
~
3
50 Hz
3 x 1,5 mm
2
1
2
3
5 mm
20 mm
C
F
2
3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Sunilus screen io

Tabla de contenido