Resetting The Headset; Tips For Nokia Bluetooth Phones; Enhanced Features (For Bluetooth Phones With Hands-Free Profiles) - Jabra BT 250v Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

IMPORTANT: Do not hold the
button down too long when making, ending, or
answering a call. This should only be a quick tap, so you don't put the headset into
pairing mode by accident.
* See Enhanced features section for alternative call-waiting instructions for
phones that support the hands-free profile.
TIPS AND SOLUTIONS
12

Resetting the headset

If the headset is not responding or the blue light will not turn on or off after
pairing, you may need to RESET your headset.
1. Fully insert the headset into the charging cradle.
2. Plug the Jabra BT250v AC adapter into the headset's charging cradle.
3. Plug the AC adapter into the electrical outlet.
4. Leave the headset in the charging cradle for about 3 seconds, then remove the
headset (see Fig. 1).
5. Unplug the AC adapter from the charging cradle.
13

Tips for Nokia Bluetooth phones

(Such as Nokia 6310 and 8910 series)
Please ensure that the headset is allowed by the phone to connect without
authorization. To do this, you must adjust your phone's settings.
Set the following menu options:
Menu > Bluetooth > View Paired Devices > select your headset, press "Options"
> Request conn. authorization? — No
8
14

Enhanced features (for Bluetooth phones with hands-free profiles)

Enhanced features are available for phones that support the hands-free Bluetooth
profile such as Nokia 3600, 3650, 6310, 6310i, 8910, 8910i, Sony Ericsson
T610, T616, T618, Siemens S55 and S56. Check your phone's instruction guide
or contact the phone manufacturer if you are not sure if your phone supports the
hands-free Bluetooth profile.
You can enable these enhanced features by using the following alternative pairing
sequence.
"Pairing" to a Bluetooth phone with hands-free profile:
1. Ensure headset is off (see Turning
headset on/off section).
2. Press and hold and also press the
volume up button until you see a solid
blue light (approximately 8 seconds),
then release (see Fig. 5).
3. Set your Bluetooth phone to "discover"
the headset by following your phone's
instruction guide. Typically, the steps
involve going to a "setup, " "connect, " or
"Bluetooth" menu on your phone and
then selecting the option to "discover"
a Bluetooth device*.
4. Your phone will find the "Jabra BT250v"
headset and ask if you want to pair with
it. Confirm this by pressing "yes" or "ok. "
5. Enter passkey or PIN = 0000 (4 zeros),
then press "yes" or "ok. "
* Phone-specific pairing instructions and the most current list of phones with
hands-free profile can be found online at www.jabra.com
Fig. 5
Fig. 6
9

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido