Operating Procedure; Basic Operation - Sima CX-16 Manual De Instrucciones

OPERATING PROCEDURE

■Preliminary checking for preventing any accident, check as follows
without fail:
●Checking the safety at work
Use the machine with much care to the surroundings.
●Checking the working clothing
To protect yourself from danger, it is recommended to wear a clothing
suitable for the working.
●Checking the machine for abnormality
If you have detected an abnormality in the machine, immediate stop
using the machine and ask for inspection and repair of the machine.
●Checking for oil stains on machine body and grip
Such oil stains will cause the machine to slip down, possibly causing a
great danger to you or a damage to the machine.

1. Basic operation

(1) Adjust the "adjust-bolt" position to meet the diameter of rebar you
are going to cut. (The original bolt is fixed to max.16mm)
1. Loose the locknut by #17 spanner
2. Set the adjust-bolt vertical against rebar.
3. Fix the locknut #17 spanner firmly.
(2) Put the rebar between blades into the bottom.
(3) Set the rebar position you want to cut and turn on switch.
Keep the switch on till the rebar be cut.
Cutter rod will automatically return to original position after cutting.
(4) Take off the rebar after switching off.
2. Operating Return Valve
To return the rod its position it reaches the stroke end, loosen the
return valve.
(1) When the return valve is loosened, a half turn counterclockwise. The
hydraulic pressure will be reduced and the cutter rod will return to
start position.
(2) To resume cutting, securely tighten the return valve clockwise before
starting the machine. If the return valve is left loosened, no hydraulic
pressure is applied and thus no cutting can be done.
CAUTION
●Never loosen the return value more than
necessary. Excessive loosening will cause
oil leak or missing of the valve.
Body 360
3.
°
The machine body can rotate 360°on no-pressure.
return
6