Navitrack Ii Maintenance Instructions; Transportation And Storage; Installing/Using Accessories; Maintenance And Cleaning - RIDGID NaviTrack II Manual Del Usuario

In the final analysis there is one "most important" com-
ponent in the locating task – the operator. The NaviTrack
II gives an operator an unprecedented amount of infor-
mation to be able to make the correct decision rapidly and
accurately.
NaviTrack II Maintenance

Transportation and Storage

Before transporting make sure that the unit is turned off
to preserve battery power.
When Transporting make sure that the unit is secure and
does not bounce around or get bumped by loose equip-
ment.
The NaviTrack II should be stored in a cool dry place.
NOTE! If storing the NaviTrack II for an extended period
of time then the batteries should be removed.
If shipping the NaviTrack II, remove the batteries from
unit.

Installing/Using Accessories

The NaviTrack II also comes with Sonde and Pole Markers
that can be used to mark Pole or Sonde locations above
ground. There are two (2) red markers to mark the Poles
and one (1) yellow marker to mark the Sonde. The mark-
ers can also be used to temporarily mark points to come
back to while scouting a target area or tracing a line.
If further assistance is needed, please call:
RIDGE Tool Technical Service at 800-519-3456. If ap-
propriate: Replacements can be ordered from your
RIDGID dealer.

Maintenance and Cleaning

1. Keep the NaviTrack II clean with a damp cloth and
some mild detergent. Do not immerse in water.
2. When cleaning, do not use scraping tools or abrasives
as they may permanently scratch the display. NEVER
USE SOLVENTS to clean any part of the system.
Substances like acetone and other harsh chemicals
can cause cracking of the case.

Locating Faulty Components

For troubleshooting suggestions, please refer to the
trouble-shooting guide on page 32 . If necessary, contact
RIDGE Tool Technical Service at 800-519-3456. We will
establish a plan of action to get your NaviTrack II work-
ing for you.

Service and Repair

Instrument should be taken to a RIDGID Independent
Authorized Service Center or returned to the factory.
Remove batteries entirely before shipping. All repairs
made by Ridge service facilities are warranted against de-
fects in material and workmanship.
CAUTION
If you have any questions regarding the service or repair
of this machine, call or write to:
Ridge Tool Company
Technical Service Department
400 Clark Street
Elyria, Ohio 44035-6001
Tel: (800) 519-3456
E-mail: TechServices@ridgid.com
For name and address of your nearest Independent
Authorized Service Center, contact Ridge Tool Company
at (800) 519-3456 or http://www.ridgid.com
Ridge Tool Company
NaviTrack ® II
WARNING
Remove batteries entirely before shipping.
29