Pulsar Forward FN135 Manual De Instrucciones página 16

Problem Check
The unit is wrongly adjusted.
The unit will not
focus.
Wireless remote Remote control is not
control will not activated.
operate.
Low battery.
Smartphone or tablet Password in the unit was
PC cannot be changed.
connected to the
unit.
There are too many Wi-Fi
networks in the area where
the unit is located which may
cause signal interference.
Poor image quality / Problems described may arise in adverse weather conditions
Detection range (snow, rain, fog etc.).
reduced.
Barely visible texture This is normal for eye safe
which does not laser IR illuminators.
hinder detection
range or efficiency of
observation can be
noticed on the
display after the
extra laser IR
Illuminator (AL915)
is activated.
The clamp of the Wrong insert is chosen.
adapter cannot be
opened.
25
Corrective action
Adjust the unit according to the
instructions given in the
Section "OPERATION" and
check the surfaces of the
eyepiece and objective lenses
and clean them if necessary
from dust, condensation, frost,
etc; to prevent fogging in cold
weather, apply a special anti-
fog solution.
Activate the remote control
according to instructions.
Install a new CR2032 battery.
Delete network and connect
again inserting the password
saved in the unit.
To ensure stable Wi-Fi
performance, move the unit to
an area with few or no Wi-Fi
networks.
This is not a defect.
Choose the appropriate insert.
Check the gap between the lips
of the adapters.
26