Section 6 − Operating The Welding Generator; Engine Controls - Miller Blue Star 145DX Manual Del Proprietário

SECTION 6 − OPERATING THE WELDING GENERATOR

6-1. Engine Controls

3
1 Engine Switch
Use switch to control ignition circuit. Turn
switch to Start position for electric start. Turn
switch to Off position to stop engine.
2 Low Oil Level Light
Light goes on and engine stops if engine oil
level is too low.
Engine cannot be restarted until sufficient oil
is added.
!
Stop engine and add oil if light goes on
(see Section 5-5).
3 Starter Handle
Use starter handle to start unit if electric start
does not work.
OM-248 551 Page 24
4
4 Choke Control
Use control to change engine air/fuel mix.
Move control to far right if starting a cold en-
gine. Move control to far left if starting a warm
engine.
The engine starts at weld/power speed and
runs at weld/power speed under weld or gen-
erator power load. With Run/Idle selected, the
engine returns to idle speed 12 seconds after
start-up or after weld or generator power load
is removed.
To Start:
D Open fuel valve (see Section 5-5).
D Set choke.
.
Complete Parts List available at www.MillerWelds.com
D Electric-Start: Turn Engine switch to
Start position.
Recoil: Turn Engine switch to On posi-
tion. Pull starter handle until engine
starts.
D Open choke as engine warms.
!
If the engine does not start, let engine
come to a complete stop before at-
tempting restart.
To Stop:
D Turn Engine switch to Off.
.
Always close fuel valve after stopping
unit. Moving unit with fuel valve open may
cause carburetor flooding and make
starting difficult.
1
2
803 595