Front Panel Controls - Miller Blue Star 145DX Manual Del Proprietário

6-2. Front Panel Controls

2
1
1 Welding Range Table
Use table to determine correct weld amper-
age based on electrode size, type, and mate-
rial thickness.
2 Run / Idle Switch
Use switch to select whether the engine stays
at run speed continuously or whether the auto
idle feature is enabled so engine speed re-
turns to idle speed after start−up or after weld
or generator load is removed.
4
3 Weld Output Control
.
Set control at maximum for full generator
power output at AC receptacles.
Use control to select weld amperage. Control
may be adjusted while welding.
To Set Weld Output Control: Use table to
determine correct size electrode for weld am-
perage. Select electrode type and set control
to corresponding amperage range on name-
.
Complete Parts List available at www.MillerWelds.com
plate. Adjust control to obtain desired weld
performance.
EXAMPLE:
Electrode Diameter: 1/8
Electrode Type: E-6013
Current Control Setting: 90 − 120 A
4 Hour Meter
Use hour meter to help schedule routine main-
tenance.
3
218 610
OM-248 551 Page 25