Sharp CV10CTXB Manual De Instalación Y Funcionamiento página 22

OPERATION OF WIRELESS REMOTE CONTROL
Notice: This is a general use remote controller, it could be used for the air
conditioners with multifunction.
• Names and functions of wireless remote control
Note: Be sure that there are no obstructions between receiver and remote controller;
Don't drop or throw the remote control; Don't let any liquid in the remote control and
put the remote control directly under the sunlight or any place where is very hot.
Remote control
ON/OFF
ON/OFF button
•
Press this button, the unit will be turned on,
press it once more, the unit will be turned
off. When turning on or turning off the unit,
the Timer, Sleep function will be cancelled,
but the presetting time still remains.
MODE
MODE button
•
Press this button, Auto, Cool, Dry
(Dehumidification), Fan mode can be
selected circularly. Auto mode is
default while power on.
mode, the temperature will not
displayed; (Under Heatmode, the
initial value is 28ºC (82ºF));
modes, the initial value is 25ºC (77ºF).
AUTO
COOL
DRY
FAN
HEAT
Signal transmitter
T-ON T-OFF
AUTO
COOL
SLEEP
DRY
LOCK
FAN
SPEED
ON/OFF MODE
-
+
FAN
SLEEP TIMER
Under Auto
be
Under other
AUTO DRY
COOL
HEAT FAN
.
(HEAT mode is not available
on this unit)
SLEEP
SLEEP button
• Press this button, Sleep On and Sleep
Off can be selected. After powered on,Sleep
Off is defaulted. After the unit is turned off,
the Sleep function is cancelled. After Sleep
function set up, the signal of Sleep will
display.
Under Fan and Auto modes, this function is
not available.
FAN
FAN button
• By pressing this key,you may select AUTO, FAN
1, FAN 2, FAN 3 or FAN 4, and may also cycle
between them. FAN 4 only in cool mode. After
being powered on, AUTO is defaulted. Only
LOW fan can be set under DRY mode, pressing
this key can not adjust the fan speed, but can
send message.
(Note: When select Fan 4, the fan speed is same
as fan3 on this unit)
AUTO
Fan 1
Fan 3
EN-20
Fan 2
Fan 4