Install Window Panel - Sharp CV10CTXB Manual De Instalación Y Funcionamiento

INSTALL WINDOW PANEL

Installation in a double-hung sash window
1
Connect the rain guards to the insect
guard net.
Insert all three projections on each rain
guard into the holes in the insect guard net.
Side "A" will now be at the top, as indicated
in the diagram.
2
Attach the guard combined above to
the window pane
Push the insect guard net firmly to ensure
that its four projections fit into the holes in
the window panel.
Side "A" will now be at the top, as indicated
in the diagram.
3
Cut the foam seal A to the proper
length and attach it to the window
sill.
4
Attach the window panel to the
window sill.
If the inner width of the window is between
22"(559mm) and 24"(609mm) inclusive
The window panel cannot be installed in
windows less than 22" (559mm) wide, as
you will be unable to shut the exhaust cover.
(1) Remove the adjustment panel from
the window panel, and cut the window
panel to the same width as the window.
(2) Open the window sash and place the
window panel on the window sill.
(3) Secure the window panel to the window
sill with 2 screws.
l.
EN-12
Insect guard net
Projec-
tion
Saliente
"A"
Exhaust cover
Window
panel
Adjustment
panel
22"-24"
Hole
Rain guard
"A"
Panel de ventana
Foam seal A
(adhesive type)
Cut
Window panel
Window sill