Sharp CV10CTXB Manual De Instalación Y Funcionamiento página 24

OPERATION OF WIRELESS REMOTE CONTROL
Guide for operation- General operation
1. After powered on, press ON/OFF button, the
unit will start to run.
2. Press MODE button, select desired running
mode, enter into the corresponding operation
directly.
3. Pressing + or - button, to set the desired
temperature. (It is unnecessary set the temp. at
AUTO mode.)
4. Pressing FAN button, set fan speed, can select
AUTO, FAN 1, FAN 2, FAN 3 or FAN 4. (Note:
When select Fan 4, the fan speed is same as
fan 3 on this unit)
Guide for operation- Optional operation
1. Press SLEEP button, to set sleep.
2. Press TIMER button, can set the scheduled
timer on or timer off.
Introduction for special function
• About AUTO RUN
When AUTO RUN mode is selected, the setting
temperature will not be displayed on the LCD,
the unit will be in accordance with the room
temp. automatically to select the suitable
running method.
• About LOCK
Under switch-on or switch-off state, you may
hold "+" and "-" key simultaneously to lock and
unlock the keypad. When locked, the display
will show the LOCK icon, in which case the lock
icon will flash three times upon operation of
any key. After the keypad is unlocked, the lock
icon on the display will be hidden. After initially
powering on, the default is unlock.
• About switch between Fahrenheit and
Centigrade
Under switch-off state, you may hold "-" and
"MODE" keys simultaneously to
switch between ºC and ºF.
• About Lamp
Under switch-on or switch-off state, you may
hold "+" and "FAN" key simultaneously for 3
seconds to set the lamp on or off and send the
code. After initially powering on, the lamp is
defaulted on.
1
ON/OFF
3
4
SLEEP
ON/OFF
1
SLEEP
EN-22
MODE
-
+
FAN
TIMER
MODE
-
+
FAN
TIMER
2
2