Sharp CV10CTXB Manual De Instalación Y Funcionamiento página 23

T-ONT-OFF
AUTO
COOL
DRY
FAN
ON/OFF
-
Remote control
FAN
SLEEP
+
+ button
• For presetting temperature increasing.
Press this button, to set up the
temperature, when unit is on . Continu-
ously press and hold this button for
more than 2 seconds, the correspond-
ing contents will be changed rapidly,
until unpress the button then send the
information, Cº (ºF) is displaying all
along. In Auto mode, the temperature
can not be set up, but operate this
button can send the signal. Centigrade
setting range :16-30; Fahrenheit setting
range 61-86.
-
- button
• Presetting temperature can be
decreased. Press this button, the
temperature can be set up, continu-
ously press this button and hold for two
seconds, the relative contents can
quickly change, until unhold this button
and send the order that the ºC (ºF)
signal will be displayed all the time. The
temperature adjustment is unavailable
under the Auto mode, but the order can
be sent by if pressing this button.
TIMER
SLEEP
LOCK
SPEED
MODE
+
TIMER
EN-21
TIMER button
• By pressing this key under switch-off state,
you may set the time for auto switch-on. The
range of setting is 0.5 ~ 24 hours. The
characters "T-ON" and "H" will flash for 5
seconds. Within 5 seconds, you may make
one press of this key to complete the setting
and send the message.If the setting is valid,
the set time will be displayed for 2 seconds
before display of the temperature message.
During flash,you may press "+" key to
increase the value and press "-" key to
decrease the value. The time will increase or
decrease by 0.5 hours with each press of this
key.If pressing "+" or "-" key continuously,
the time value will change rapidly. The
remote controller can increase the set time
by 0.5 hours every 0.25 seconds. After being
powered on, the fault is no timer setting, and
there is no display of "T-ON" or "H". Press
ON/OFF key to switch on the unit and cancel
the auto switch-on.When the temperature
display becomes constant, you may press
this key again to display the remaining set
time. The time value, "T-On" and "H" will
display constantly for 2 seconds. After 2
seconds,the preset temperature will be
displayed within these 2 seconds, you may
press this key again to cancel the auto
switch-on and send the message.
• By pressing this key under switch-on state,
set the time for auto switch-off.