Operation Control And Description - GALAGAR KENNEDY 140 Manual Técnico De Instrucciones

Gala Gar

4. OPERATION CONTROL AND DESCRIPTION

●
Front control panel
1. "+" output terminal: To connect the electrode holder.
2. "-" output terminal: To connect the work clamp.
3. Welding current knob: To adjust the output current.
4. Power LED: To indicate the power. Power LED on indicates that the power switch of the
machine is on.
5. Overheating LED: To indicate overheating. Overheating LED on indicates that the
temperature inside the machine is too high and the machine is under overheating protection
status.
6. MMA/TIG switch: To toggle between MMA and TIG.
●
Back control panel
7. Power input: Power input cable.
8. Power switch: Power ON/OFF switch.
9. Fan
(see Figure 1)
(see Figure 2)
Figure 1 Figure 2
15