Items Supplied; Proper Use - EINHELL BT-MR 550 Manual De Instrucciones

Anleitung_BT_MR_550_SPK7:_
Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.
1. Layout (Figs. 1-4)
1. Routing head
2. Compound table
3. Machine column
4. Work spindle
5. Gear lever
6. Speed selector switch
7. Wheel selector for fine feed
8. ON/OFF switch
9. Ring gear drill chuck
10. Hand crank for cross slide
11. Hand crank for saddle slide
12. Depth stop
13. Fixing nut for angle adjustment
14. Star handle
15. Spindle guard
16. Chip guard

2. Items supplied

Drilling and routing machine
Drill chuck key
Hook spanner
Locating pin
Tools

3. Proper use

This machine is designed for the drilling, deep
routing and face routing of small workpieces (max.
dimensions: 300 mm x 200 mm x 200 mm) made
from metal, plastic or similar materials. Only drilling
and routing tools with a cylindrical shaft of max. 16
mm may be used with the standard ring gear drill
chuck. The tool diameter for the machining of metal
(ST37) must be no more than 13 mm. Tools with a
tapered shank (MK3) can also be mounted directly in
the work spindle. This drilling and routing machine is
17.12.2008 9:00 Uhr Seite 15
suitable only for household use and must not be
used for industrial applications. The machine is to be
used only for its prescribed purpose. Any other use is
deemed to be a case of misuse.
The user/operator and not the manufacturer will be
held liable for damage and/or injuries of any kind that
result from such misuse. To use the machine
properly you must also observe the safety
regulations, the assembly instructions and the
operating instructions to be found in this manual. All
persons who use and service the machine have to
be acquainted with this manual and must be
informed about the machineʼs potential hazards. It is
also imperative to observe the accident prevention
regulations in force in your area. The same applies
for the general rules of health and safety at work.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
The manufacturer will not be liable for any changes
made to the machine nor for any damage resulting
from such changes. Even when the machine is used
as prescribed it is still impossible to eliminate certain
residual risk factors. The following hazards may arise
in connection with the machinesʼ construction and
design:
Contact with the jaw chuck where it is not
covered.
Reaching into rotating parts (risk of injury).
Catapulting of workpieces and parts of workpieces
from the machine.
Harmful coolants and lubricants. Make sure they
are disposed of in an environmentally friendly
manner.
Contact with rotating components where they are
not covered. Risk of injury!
Caution! Risk of injury! Always withdraw jaw chuck
keys immediately and never leave them inserted
in the chuck!
Risk of injury from the routing tool even when it is
not in use.
Eye injuries can be caused by flying chips and
other splinters. You MUST wear safety goggles!
GB
15