Layout And Items Supplied - EINHELL TC-BD 450 Manual De Instrucciones

Maintain a steady foothold
Ensure that you maintain a steady foothold while
working. Avoid abnormal body positions and al-
ways keep your balance.
Pull out the mains plug
Pull out the mains plug when not using the tool,
prior to maintenance, and when changing the drill
bit.
Pull out the power plug.
Ensure that the mains connection is protected by
at least a 10 A-rated fuse.
Avoid unintentional start-up
Ensure that switch is turned off when plugging the
plug into the socket.
Keep an eye on your work
Always keep an eye on your machine and the
object you are working on. Never use the machine
when you are not concentrating or are distracted.
Never use the machine when you are under the
influence of alcohol or are taking medication.
Maximum piece size
Only workpieces (max. 20 x 20 cm) that can be
securely clamped on the drilling table or in the
vice may be processed.
Check the tool for damage
Before using the tool, safety devices and any
slightly damaged parts must be carefully checked
to ensure that they are in good working order. Vi-
sually examine the tool's power cable on a regular
basis. All parts must be correctly assembled and
meet all the conditions required to ensure proper
operation. Unless otherwise specified in the ope-
rating instructions, any damaged safety devices
and parts must be properly repaired or replaced
by a professionally recognized workshop. Never
use tools with defective On/Off switches.
Warning! Using any plug-in tools and accesso-
ries other than those specified in these operating
instructions can lead to injury.
Now, please read and follow all steps and
procedures included in the operating instruc-
tions.
Anl_SA_TC_BD_450_SPK8.indb 30 Anl_SA_TC_BD_450_SPK8.indb 30
GB

2. Layout and items supplied

2.1 Layout (Fig. 1)
1. Machine base
2. Pillar
3. Fixing screw
4. Drill table
5. Clamping screw
6. Machine head
7. V-belt cover
8. Motor
9. Grip knobs
10. Scroll chuck
11. Spindle
12. Mounting holes
13. Folding chip guard
14. Depth stop
15. Locking screw for V-belt cover
16. Tightening screw
17. Clamping lever
18. ON switch
19. OFF switch
20. Stop screw for chip guard
21. Holder for chip guard
22. Securing screw for chip guard
23. Fastening rail for chip guard
24. Chuck size
25. Scale ring
26. V-belt
27. Drill chuck key
28. Socket head screw
29. 10 mm hex key
30. 6 mm hex key
2.2 Items supplied
Please check that the article is complete as
specified in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made bought the product
within the maximum days indicated by the con-
sumer protection laws of your country and upon
presentation of a valid bill of purchase. Also, refer
to the warranty table in the service information at
the end of the operating instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
- 30 -
19.07.2022 13:18:28 19.07.2022 13:18:28