Layout And Items Supplied; Proper Use; Technical Data - EINHELL TC-ID 720/1 E Manual De Instrucciones Original

c) Do not exert any excessive pressure.
Pressure should only be exerted in the
longitudinal direction of the drill bit. Drill
bits can bend, causing them to break or lea-
ding to a loss of control and to injury.
Additional safety instructions
•
The drill is not designed for use with attach-
ments.
•
Do not use near vapors or inflammable li-
quids.
•
Make sure you have a steady foothold when
working on ladders and platforms.
•
Prior to drilling in walls where electricity, water
or gas lines are concealed, use a cable/pipe
detector to locate the lines.
Do not lose this safety information.

2. Layout and items supplied

2.1 Layout (Fig. 1)
1. Drill chuck
2. Depth Stop
3. Drill/hammer drill selector switch
4. Locking button
5. ON/OFF switch
6. Speed controller
7. Clockwise/Counter-clockwise switch
8. Additional handle
9. Chuck key
2.2 Items supplied
Please check that the article is complete as
specified in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made bought the product
within the maximum days indicated by the con-
sumer protection laws of your country and upon
presentation of a valid bill of purchase. Also, refer
to the warranty table in the service information at
the end of the operating instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Anleitung_SA_TC_ID_720_1_E_SPK8.indb 24 Anleitung_SA_TC_ID_720_1_E_SPK8.indb 24
GB
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suffocating!
•
Hammer Drill
•
Depth stop
•
Original operating instructions
with safety instructions

3. Proper use

The impact drill is designed for drilling holes into
wood, iron, non-ferrous metals and for impact dril-
ling in stone, using the appropriate bits.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

See warranty card of your country.
Wear ear-muffs.
The impact of noise can cause damage to hea-
ring.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect con-
ditions.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
Caution!
Residual risks
Even if you use this electric power tool in
- 24 -
04.08.2022 08:49:26 04.08.2022 08:49:26