Shindaiwa 270 Serie Manual Del Propietário página 9

Assembly (continued)
Brushcutter Blade C270
NOTE:
The C270 is shipped with Holder A, the
safety clip, Holder B, and also the shaft
bolt and bolt guard installed. The shaft
bolt is a LEFT-HAND THREAD AND IS
REMOVED BY TURNING CLOCKWISE!
Turn the C2510 upside down so the
gear case output shaft is facing UP and
remove the shaft bolt, bolt guard and
holder B from the gear case shaft.
1. Align the hole in blade holder A
with the matching hole in the gear
case flange and then temporarily
lock the output shaft by inserting
a hex wrench through both holes.
See Figure 14.
2. Slide the safety clip off-center. See
Figure 14A.
3. Fit the blade over the safety clip and
then center it over the flange on
holder A. See Figure 14B.
CAUTION!
Install the blade so its printed sur-
face is visible to the operator when the
brushcutter is in the normal operating
position.
WARNING!
The blade must fit flat against the
holder flange. The blade mounting hole
must be centered over the raised boss
on blade holder A.
NOTE:
When installing certain blades, it may
be necessary to temporarily remove the
safety clip.
4. Lock the blade in place by centering
the safety clip on the output shaft.
See Figure 14C.
WARNING!
Never operate the C270 without the
safety clip in place!
IMPORTANT!
The machined recess in holder B must
completely surround the safety clip, and
both holders must be flat against the sur-
face of the blade.
Shaft Bolt
Hex Wrench
27018
Figure 14
Figure 15
5. Install blade holder B on the output shaft.
See Figure 15. The recess in the holder
must completely cover the safety clip, and
must fit tightly against the blade.
6. Install the bolt guard and then the blade
retaining bolt. Using the combination spark
plug wrench/screwdriver, tighten the bolt
firmly in a counter-clockwise direction.
7. Remove the hex wrench.
Bolt Guard
Holder B
Gear Shaft
Safety Clip
Figure 14A
Holder A
Slip the Cutting Blade
Figure 14B
Install Holder B
Saw
Blade
Hex Wrench
The C270 should now be
Install the
Safety Clip Off-
center
27019
27019B
Center the Safety Clip
in Place
Figure 14C
Spark Plug
Wrench
Tighten the Assembly
BLADE NOT SHOWN FOR
CLARITY!
completely assembled.
9