Assembly - Shindaiwa 270 Serie Manual Del Propietário

Assembly

Adjusting free Play
The throttle lever free play should be approx-
iamtely 7mm. See Figure 5. Make sure that
the throttle lever operates smoothly without
binding. If it becomes necessary to adjust
the lever freeplay, follow the procedures and
illustrations that follow.
1. Loosen the lock nut on the cable
adjuster. See Figure 5.
2. Turn the cable adjuster in or out as
required to obtain proper free play of
9/32 inch (7mm). See Figure 5.
3. Tighten the locknut.
Handle T270
Handle
Outer Tube
Figure 6
Handle C270
Spacer
Lower Cap
Retaining Screws
Figure 7
6
Figure 5
Handle Retaining
Screws
27007
Nuts
Handlebar
Handle Positioning Label
Lower Cap
7 mm
Free
Play
27043
Handle Positioning Label
Barrier Bar
27008
Cable
Adjuster
Locknut
1. Position the handle on the outer tube
forward of Handle Positioning Label as
shown in Figure 6.
2. Install the handle and barrier bar onto
the outer tube with the socket head cap
screws and nuts as shown in Figure 6.
Tighten the screws finger-tight ONLY
at this time.
3. Locate the handle in the best position
for operator comfort (usually about 10
inches ahead of the throttle housing).
4. Secure the handle by alternately tight-
ening the four socket-head screws in a
diagonal or "crisscross" fashion.
1. Use the 4 mm hex wrench to remove
the lower cap retaining screws from
the handlebar bracket. Remove the cap
from the bracket, and note the position
of the two spacers installed between the
bracket halves. See Figure 7.
2. Position the handle on the outer tube
forward of Handle Positioning Label
as shown in Figure 7. Reassemble the
lower cap to the handlebar bracket in
the reverse order of disassembly.
3. Locate the handle in the best position
for operator comfort.
4. Firmly tighten both lower cap retaining
screws.