Installation; Prior To Installation; Flush Installation Of Built-In Grill - bora PT 11-000 Instrucciones De Montaje Y De Uso

Installation

Prior to installation

■ The built-in grill is designed for installation
associated control unit is built into the bottom cabinet front cover
■ The grill must be installed and connected to the power supply according to the
instructions in this manual. All installation work must be carried out by an
approved installer/electrician.
■ Dispose of the packaging material according to the applicable statutory
regulations.

Flush installation of built-in grill

The distance between the cut-out edge and the rear and side walls must be
minimum 50 mm.
For installation in built-in kitchen units, ensure that the plastic or veneer of the
■
units is applied with heat-resistant adhesive as it might otherwise become
loose or deformed, especially at the edges.
Seal the exposed cut-out edge with a sealant such as
■
369,5
374
R5
into a cut-out in a
cut-out
dimensions
346 x 516
silicone.
worktop. The
14
5