Transport And Installation En; Risk Of Injury - Abicor Binzel iROB Cool Manual De Instrucciones

iROB Cool
6.1 Transport and installation
The iROB Cool coolant recirculator may only be used in connection with the iROB Pulse robot welding
power source. The coolant recirculator is located under the robot welding power source and is connected
to it.

Risk of injury

Physical damage due to falling devices and mounting parts.
• Use an appropriate lifting tool with load handling devices for transport and installation of the
• Avoid abrupt lifting and setting down.
• Do not lift the components over persons or other devices.
• Transport the components in upright position.
• Wear your personal protective equipment: safety shoes with steel caps, work protective gloves, safety
• Expel bystanders out of the danger zone.
• Please observe the weight of the individual components.
Risk of toppling
Physical damage or damage to components due to improper mounting.
• Separate the supply lines.
• Place the components on a suitable base (flat, tight, dry) that prevents them from tipping.
• Please observe the max. angle of inclination of 10°.
NOTICE
• Ensure free access to the operating components and connections.
• Install the coolant recirculator with the robot welding power source maintaining a circumferential
• Prevent dust and other foreign substances from entering the cool air stream of the system.
• Protect the components against rain and direct solar radiation.
• Components must only be used in dry environments with sufficient ventilation.
BAL.0332.0 • 2017-08-31
CAUTION
iROB Pulse robot welding power source.
helmet and ear protection.
 3.1 Technical data on page EN-6
CAUTION
clearance of 50 cm to ensure the optimum circulation of the cooling air.
6 Putting into operation
EN - 11