Putting Out Of Operation; Maintenance And Cleaning - Abicor Binzel iROB Cool Manual De Instrucciones

iROB Cool

8 Putting out of operation

NOTICE
• Please make sure that the shutdown procedures for all components mounted in the welding system are
1 Pull the mains plug at the robot welding power source.

9 Maintenance and cleaning

Under normal operating conditions, the coolant recirculator does not require maintenance. Regular
cleaning, however, is a prerequisite for a long life and a trouble-free operation.
The coolant pump has a service life of approx. 10,000 operating hours. After this time has elapsed, the
pump must be replaced.
Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of maintenance, servicing, mounting,
dismounting and repair work:
• Switch off the power source.
• Close the gas supply.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
Risk of burns
Risk of burns due to escaping hot coolant and hot surfaces.
• Switch off the cooling device before starting maintenance, servicing, mounting, dismounting and
• Wear protective gloves.
NOTICE
• Maintenance and cleaning work may only be carried out by qualified personnel
• Check coolant hoses, seals, and connections for damage and tightness. Replace as necessary.
• Always wear your personal protective equipment when performing maintenance and cleaning work.
BAL.0332.0 • 2017-08-31
strictly observed before putting out of operation begins.
DANGER
DANGER
DANGER
repair work.
(in Germany see TRBS 1203).
8 Putting out of operation
EN - 17