Dismounting - Abicor Binzel iROB Cool Manual De Instrucciones

iROB Cool

11 Dismounting

Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of maintenance, servicing, mounting,
dismounting and repair work:
• Switch off the power source.
• Close the gas supply.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
Risk of burns
Risk of burns due to escaping hot coolant and hot surfaces.
• Switch off the cooling device before starting maintenance, servicing, mounting, dismounting and
• Wear protective gloves.
NOTICE
• Dismounting may only be carried out by qualified personnel (in Germany see TRBS 1203).
• Observe also the operating instructions of the welding components, such as the iROB Pulse robot
• Observe the information given in the following chapter:
1 Unscrew the screwing of the robot welding power source and the coolant recirculator on the front and
back side
Risk of injury
Limbs can be crushed and sheared.
• Use appropriate lifting tool with load handling devices for transport and installation.
NOTICE
• Use appropriate crane with suitable load handling devices for transport and installation of the
• Observe the safety instructions of the crane manufacturer.
2 Lift the robot welding power source slightly at the front side.
BAL.0332.0 • 2017-08-31
DANGER
DANGER
repair work.
welding power source and welding torch.
 8 Putting out of operation on page EN-17.
WARNING
iROB Pulse robot welding power source.
11 Dismounting
EN - 21