DeVilbiss Cvi Manual De Operación página 4

Page 4 SB-2-658-G
Patent No. 2372465 (GB)
P RTS LIST
Ref.
No. Description
1 ir Cap/Retaining ring
2 Fluid Tip
+ 3 Separator
+ 4 Needle Packing
5 Spreader Valve
6 Stud and Screw
7 Needle djusting Screw
+ 8 Fluid Needle Spring
9 Fluid Needle
10 irvalve Housing & Seal
11 irvalve Spindle
12 Trigger, Stud & Screw Kit
13 Connector
14 irflow Valve
16 ir Valve Service Kit
17 Retaining Ring and Seals
+18 Clip, Seal and Pin Kit
23 ir Valve ssembly Tool
24 Spanner
Spraygun Service Kit
(parts included marked + )
CH RT 1
Order No.
pplication
for ir Cap
Basecoats – Solvent &
802841
Waterborne, Clears,
(HVLP
Single Stages, Primers
Basecoats – Solvent &
802546
Waterborne, Clears,
(High Eficiency)
Single Stages, Primers
Number Recommended
ir Flow
on Inlet Pressure
(LPM / SCFM)
ir Cap (B R / PSI)
1.0 – 1.2 B R 283 – 368 LPM
505
14 – 18 PSI 10 – 13 SCFM
1.4 – 1.8 B R 212 – 255 LPM
510
20 – 26 PSI 7.5 – 9 SCFM
Part Number Qty. Options
SP-100-***-K 1
505, 510 e.g *** = 510
SP-200S-**-K 1
10, 12, 13, 14 e.g ** =13 =1.3 mm
SP-626-K5 5
GTI-445-K2 2
SP-403-K 1
1
SP-614-K 1
SP-622-K5 5
SP-300S-**-K 1
10, 12, 13, 14 e.g ** =13 =1.3 mm
SP-612-K 1
1
SP-617-CR-K 1
SP-611-K 1
SP-402-K 1
SPK-101-K 1
SPK-102-K 1
GTI-428-K5 5
1
SPN-5-K 1
SPK-402-K 1
NOTE 1:
Recommended
HVLP cap must not exceed 0.7 bar (10 psi) air cap pressure with
Fluid Tip (MM)
gun fully triggered to maintain HVLP compliance (approximately
18 psi gun inlet pressure).
See CCESSORIES for air cap test kit which is available to set the
1.2, 1.3, 1.4
exact cap pressure.
(also 1.6 for
waterborne only)
Compliance with SC QMD and other air regulatory agencies
requires gun inlet pressure not to exceed 26 psi with gun fully
1.2, 1.3, 1.4
triggered when the high efficiency cap is used. Gun inlet pressure
(also 1.6 for
may be adjusted as required to any desired value in areas not
waterborne only)
requiring EP compliance.
NOTE 2:
When removing air cap from retaining ring, do not remove cap
slip ring or retaining ring seal from retaining ring. Damage to the
parts may occur. Slip ring and retaining ring seal are not available
as replacements. Simply wipe parts clean and reassemble with
new or clean air cap.