Tabla de contenido
Publicidad
3
07
Drill pilot holes then remove the drilling template
IMPORTANT: Be sure to drill into the center of the stud.
IMPORTANT: Pilot holes must be drilled to a depth of 3 ½ in. (89 mm),
using a 7/32 in. (5.5 mm) diameter drill bit.
4
3 ½ in. (89 mm)
09
7/32 in.
(5.5 mm)
.
07
Install the wall plate
Tighten all lag bolts only until they are pulled firmly against the wall plate.
lag bolt. DO NOT over-tighten the lag bolts.
Go to STEP 3 on PAGE 14.
10
08
using four lag bolts
08
CAUTION:
Improper use could reduce the holding power of the
and washers
.
09
10
11
Publicidad
Tabla de contenido
