Analogue Outputs - Parker Pneudri Maxi Manual De Instrucciones

4

Analogue Outputs

There are two linear 4-20mA analogue outputs fitted as standard. These are used for the optional retransmission of the
pressure and dewpoint readings. To access these outputs, there are glands to allow access already present in the
control box but ae sealed.
Output voltage (no load) =
Resolution =
Maximum load =
Error =
X01 - 13 Pressure signal 4-20mA
X01 - 14 Pressure signal ground (do not remove existing cable)
X01 - 15 Dewpoint signal 4-20mA
X01 - 16 Dewpoint signal ground
Pressure 0 - 16 barg g, 0 - 232psi g, 0 - 1.6 MPa = 4 - 20mA
Dewpoint - 100 o C to 20
24VDC
0.005mA
500ohm
+
0.5% typical
-
+
2.5% maximum
-
o C, - 148 o F to 68 o F = 4 - 20mA
12