Electrolux ELFE4222AW Manual De Instrucciones página 11

4. Using an UNPLUGGED, UL-approved,
30 amp. power cord, NEMA 14-30 type
ST or SRDT, attach the ground (GREEN)
power cord wire to the cabinet with the
ground (GREEN) screw. Tighten the screw
securely.
2
Ground GREEN screw
1
GREEN ground wire
2
5. Move the internal (WHITE) dryer harness
wire to the terminal block and attach it
along with the neutral (WHITE) power cord
wire conductor to the center, SILVER
colored terminal on the terminal block.
Tighten the screw securely.
1
3
Neutral silver terminal
1
Internal WHITE harness wire
2
WHITE neutral wire
3
Installation Instructions
6. Attach the RED and BLACK power cord
1
7. Reinstall the terminal block access cover.
Do not make a sharp bend or crimp wiring/
conductor at connections.
Do not operate dryer without terminal cover
in place. A correctly installed terminal block
2
cover also acts a qualified strain relief for the
power cord.
conductors to the outer, BRASS colored
terminals on the terminal block. Tighten
both screws securely.
1
2
2
Brass Terminal
1
BLACK or RED power wire
2
WARNING
ELECTRICAL SHOCK HAZARD
WARNING
ELECTRICAL SHOCK HAZARD
11
1