Endress+Hauser Chroma-Log Serie Manual De Utilización página 44

3. Installation/Setting up
3.7.6 Pre-setting dotting sequence time."
Dotting sequence time" describes the time between two
dot print sequences. This can be increased when
operating on low paper chart speeds and/or slow
changing input signals. When operating with the
intelligent dotting function you reduce wear of the unit
mechanics, increase the life span of the print wheel and
lengthen maintenance intervals.
Dot sequence time selector
switch
1 - 2.5 seconds
2 - 5
3 - 10 seconds
4 - 20 seconds
5 - 40 seconds
6 - 80 seconds
7 - 160 seconds
8 - 320 seconds
9 - Calibration
0 - Off or position when changing the print wheel.
42
seconds