Description Of Buttons And Switches; Getting Started; Important Guidelines - VWR Water bath W20 Manual De Instrucciones

Description of Buttons and Switches

Getting Started

Fill the water bath with 1,3 litres of water (distilled water to avoid deposits).
Turn the unit ON by pressing the upper part of the power switch; the power switch shows
green light and the display shows actual water temperature.
To change the desired temperature, see instructions 1-2-3 in the figure above.
If you press longer than 3 seconds and the display shows P5 then reset the unit by pressing
the power switch OFF and then ON. Start at 1 again, see above.

Important Guidelines

Be careful when the emptying the water bath. First turn the unit OFF. Then disconnect the
power cord first from the mains supply and then from the unit. Please observe that the water
can be hot. Carefully empty the water from the side of the unit. Do not let water enter the back
or front of the unit. Wipe off the unit from any remaining water, leaving a dry surface.
Service and repair should only be made by an authorized technician.
Accessories
Description
Lid. Covers the water, prevents evaporation and dust contamination
4 (28)
Instruction Manual (GB)
Cat. No.
720-2424