Cutting Depth Adjustment - Craftsman Trak-Cut Manual Del Operador

10.Replace t hebladeclamping s crew & washer a nd
hand tighten it ina COUNTER-CLOCKWISE
direction,
11.Use3/16in.(5mm) h exwrench andpressspindle
lockbutton totighten thespindle clamping screw
thoroughly.
12.Place thehexwrench backinthecase.
NOTE: N EVER usea blade thatis toothicktoallow
the"0"washer t oengage withtheflatsideofthe
spindle.
CUTTING DEPTH ADJUSTMENT
/kCAUTION. Always ensure that the saw is switched off and
unplugged from the power supply before making any adjustments.
NOTE: This tool has a maximum cutting depth of 1-1/8 inch.
The cutting depth is controlled by limiting the amount of blade exposed below
the blade guard.
1. Lossen the depth lock
lever.
2. Slide the depth of cut lever
(4) upward towards the
handle grip (2) and tighten
the lever to hold the depth
stop mechanism in place.
3. Press the blade guard
release button (5) and
carefully pivot the blade guard (12) to expose
the amount of blade to achieve the desired depth
of cut.
NOTE: The measurement markings on side of the
blade guard can be used as a guide in setting the
depth of cut. The location on the blade guard that
intersects with the edge of the blade indicates roughly
the depth of cut. Always test the depth setting on a
scrap workpiece to verify the setting before cutting
into the good workpiece.
12