Extension Cords - Craftsman Trak-Cut Manual Del Operador

•
Blade depth and bevel adjusting locking levers must be tight and secure
before making a cut. If the blade adjustment shifts while cutting, it may
cause binding and kickback.
• Use extra caution when making a "Plunge Cut" into existing walls or
other blind areas. The protruding blade may cut objects that can cause
kickback.
• Do not use the circular saw near fumes or combustible liquids.
• Secure small pieces of wood firmly before working. Never hold them
in your hand.
• Never slow the blade down with your hands or by applying pressure
to the side of the blade.
• Never apply force( Advance the circular saw gently and steadily.
EXTENSION CORDS
Replace damaged cords immediately. Use of damaged cords can shock,
burn or electrocute.
If an extension cord is necessary, a cord with adequate size conductors
should be used to prevent excessive voltage drop, loss of power or
overheating. The table shows the correct size to use, depending on cord
length and nameplate amperage rating of tool. If in doubt, use the next
heavier gauge. Always use U.L. and CSA listed extension cords.
RECOMMENDED SIZES OF EXTENSION CORDS
Tool's
Ampere
rating
Volts
3 - 6 120V~
6 - 8 120V~
8 - 10 120V~
10 -12 120V~
12 -16 120V~
Total length of cord in feet. Cord size in
A.W.G. (minimum)
25 ft
(7.6 m)
18
18
18
16
14
50 ft
(15 m)
16 16
16 14
16 14
16 14
12
100 ft 150 ft
(30 m) (46 m)
14
12
12
12
8