Maytag MDE25PN Instrucciones De Instalación página 14

Ocultar thumbs Ver también para MDE25PN:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CODE
8.00
COIN SLIDE OPTION
This option is either SELECTED "ON" or NOT SELECTED "OFF."
Replacement of metercase will be needed for coin slide mounting.
8.00
Not Selected "OFF."
8. CS
Selected "ON."
NOTE: This option needs to be set to "00" unless the
metercase has been changed to accept a coin slide device.
Press DELICATES button 3 consecutive times for this
selection. When coin slide mode is selected, set "b." equal to
value of slide in coins. Set "6 xx" (REGULAR CYCLE PRICE)
and "3.xx" (SPECIAL CYCLE PRICE) to number of slide
operations. 6 01 & 3.01 = 1 slide push.
NOTE: If the installer sets up "CS" on a coin drop model,
it will not register coins.
Press PERM. PRESS button once to advance to next code.
E . 0 0
ADD COINS OPTION
This option is either SELECTED "ON" or NOT SELECTED "OFF."
This option causes the customer display to show the number
of coins (coin 1) to enter, rather than the amount.
E . 0 0
Not Selected "OFF."
E . A C
Selected "ON."
Press DELICATES button 3 consecutive times for this selection.
PN MODELS: This option is not selectable.
Press PERM. PRESS button once to advance to next code.
J . C 8
COIN/DEBIT OPTION
J . C 8
Both coin and debit selected. (NOT AVAILABLE)
J . C 8
Coins selected, debit disabled.
Press DELICATES button 3 consecutive times for this selection.
J . C 8
Debit Card selected, coin disabled. Default for PN models,
and for PN operation, must be set as J._d.
Press DELICATES button 3 consecutive times for this selection.
J . E 8
Enhanced Debit is self-selected when a Generation 2 card
reader is installed in the dryer. The "Ed" option cannot be
manually selected or deselected. (NOT AVAILABLE)
Press PERM. PRESS button once to advance to next code.
L . 0 0
PRICE SUPPRESSION OPTION
This option is either SELECTED "ON" OR NOT SELECTED
"OFF." This option causes the customer display to show
"AVAILABLE" or "ADD" rather than the amount of money
to add. (Used mainly in debit installations.)
L . 0 0
Not Selected "OFF."
L . PS
Selected "ON." Press DELICATES button once for this selection.
Press PERM. PRESS button once to advance to next code.
8. C E
CLEAR ESCROW OPTION
This option is either SELECTED "ON" OR NOT SELECTED
"OFF." When selected, money held in escrow for 30 minutes
without further escrow or cycle activity will be cleared.
8. C E
Selected "ON."
8.00
Not Selected "OFF." Press DELICATES button once to deselect
this option.
Press PERM. PRESS button once to advance to next code.
0. 0 0
HUNDREDTH INCREMENT OFFSET
0. 0 0
This represents the hundredth increment price offset used
in Generation 2 (Enhanced Debit) PN models set up with card
reader. Choose from 0–4 hundredths by pressing the WHITES
AND COLORS button. (NOT AVAILABLE)
Press PERM. PRESS button once to advance to next code.
14
EXPLANATION
If cycle counter (9 0C) is selected, the following is true:
1 00 Represents the number of cycles in HUNDREDS. 1 02 = 200
2 00 Represents the number of cycles in ONES.
This is "VIEW ONLY" and cannot be cleared.
Press the PERM. PRESS button once to advance
to next code.
If money counter (1.0C or 1.C0) is selected, the following is true:
3 00 Currency amount in HUNDREDS.
4 00 Currency amount in ONES.
5 00 Currency amount in HUNDREDTHS.
END OF SET-UP PROCEDURES
EXIT FROM SET-UP MODE
PD MODELS: Reinstall access door.
I
PN MODELS where AA1 plug was removed:
I
1. Unplug dryer or disconnect power.
2. Open console, reinsert jumper into AA1, close console.
3. Plug in dryer or reconnect power.
PN WITH PROGRAMMING SWITCH: Turn key clockwise and
I
remove.
If Service Access Code was used to enter set-up mode: From
I
Set-up Code 8, press button #1 for 4 seconds, wait 2 minutes
without touching any buttons (without diagnostic modes running),
or power down the dryer, then reapply power.
Manufacturer: Whirlpool Corporation,
1300 Marion-Agosta Rd., Marion, OH 43302, USA.
EU representatives: Maytag UK Ltd., 2 St. Annes Blvd.,
Redhill, RH1 1AX, UK & Bauknecht Hausgeräte GmbH,
D-73614 Schorndorf, Germany
Europe
2 25 = 225
TOTAL CYCLES = 225
3 01 = 100.00
4 68 = 168.00
5 75 = 100.75
TOTAL = 168.75

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mde25pdMdg22pnMdg22pdMde22pnMde22pd

Tabla de contenido