Kids36 Product Dimensions; Kids36 Cabinet Requirements - KitchenAid BRIVA KIDS42 Instrucciones De Instalación

KIDS36 Product dimensions

SIDE
1-3/4" (4.4 cm)
to center of single
hole faucet
water inlet
valve
5-25/32"
(14.7 cm)
9-7/16"
(24.0 cm)
20-21/32" (52.5 cm)
(between clamp rails)
22" (55.9 cm)

KIDS36 Cabinet requirements

*NOTE: The cutout must be accurately cut to the dimensions shown within
1/16" (1.6 mm). Dishwasher top flange overlaps the countertop cutout
by 7/16" (1.1 cm) on front and back edges and 1/4" (6.4 mm) on sides.
• Cabinetry and countertop must be sturdy enough to support loaded
dishwasher and sink (400 lbs. [181.4 kg]).
21-1/8"
(53.7 cm)
(see *NOTE)
It is recommended that sink
water and drain line
connections be located on
this side of cabinet.
factory
installed air
gaps
dishwasher
drain
for base cabinet
installations, min. 36"
(91.4 cm) width required
A
A
34" (86.4 cm)
(see *NOTE)
A
It is recommended
that dishwasher water
and drain line
connections be
located on this side
of cabinet.
FRONT
10-7/8" (27.5 cm)
to center of single
hole faucet
8"
(20.3 cm)
6-9/16"
(16.6 cm)
center of
sink drain
5-1/2 ft. (1.7 m)
3-prong ground-type
power supply cord
33-11/16" (85.6 cm)
(between clamp rails)
7/16" (1.1 cm) min.
flat surface required
C
B
25" (63.5 cm) deep
countertop
Countertop must be
level.
34-1/2" (87.6 cm)
1-1/4"
(3.2 cm)
GFCI reset
buttons
14" (35.6 cm)
18-5/16" (46.5 cm)
backsplash
21-1/8"
(53.7 cm)
(see *NOTE)
IMPORTANT: Corner radius dimensions
specified must be used. If they are not,
the dishwasher will not fit the opening.
radius: 2-1/4" (5.7 cm)
A
radius: 1" (2.5 cm) – the
B
right back corner must be
cut to this radius
C
Back right corner: If countertop is
more than 3/4" (1.9 cm) thick,
measure down 3/4" (1.9 cm) and cut
45° bevel all the way around radius.
3/4"
45°
(1.9 cm)
19-3/8"
(49.2 cm)
maximum
opened lid
height
21"
(53.3 cm)
22-1/32"
(56.0 cm)
5