Entering Pin Ii; Setting Date And Time; Setting The Timer Function Of The Deco Lighting - KBL mon amie Manual De Instrucciones

4. Press the START button to save the settings and
then press STOP to exit the menu.
MUSIC VOLUME IN STANDBY MODE
AUDIO/VOL.COOL
The menu item
order to determine the volume of the music during
a standby mode. The maximum possible volume of
the unit is at 100 %.
1. Invoke the AUDIO menu.
2. Use START to invoke the submenu and press 5
(plus button) or 0 (minus button) to select VOL.
COOL.
3. Set the desired percentage by pressing 4 (plus
button) or 9 (minus button).
4. Press START to save the settings and STOP to
exit the menu
MUSIC VOLUME IN TANNING MODE
AUDIO/VOL.HOT
The menu item
determine the volume of the music during a tanning
session. The maximum possible volume of the unit
is at 100 %.
1. Invoke the AUDIO menu.
2. Use START to invoke the submenu and press 5
(plus button) or 0 (minus button) to select VOL.
HOT.
3. Set the desired percentage by pressing 4 (plus
button) or 9 (minus button).
4. Press START to save the settings and STOP to
exit the menu.
ACTIVATING/DEACTIVATING AUDIO SOURCES
AUDIO/WPS
The menu item
which audio sources are to be made available to the
salon client. W=Wellness, P=Pop, S=Studio Music.
In the case of a top mark (apostrophe:
responding source is activated while it is deactivated
if a bottom mark is shown (comma:
sources are listed under
AUDIO
1. Invoke the menu.
2. Use START to invoke the submenu and 5 (plus
is used in
is used in order to
is used to determine
), the cor-
). All activated
AUDIO/PRESEL
.
button) or 0 (minus button) to select
Set the desired value by using the plus and minus
buttons to the corresponding letters.
3. Press START to save the settings and leave the
menu by pressing STOP.

Entering PIN II

By entering your PIN II here, you will be admitted to the next
service level. (See Settings on service level II ).

Setting date and time

The current time and date are set within the menu
TIME/DATE
item . This information is required for
the proper execution of the timer function for the
decorative lighting. Date and time are displayed for
approx. 2 seconds after the unit has been turned on.
TIME/DATE
1. Invoke the
2. Choose the time setting with START and set the
time by pressing the plus or minus buttons to the
corresponding number.
3. Choose the date setting using 5 (plus button) or
0 (minus button) and set the date by pressing
the plus or minus buttons to the corresponding
number. The day of the week is determined
automatically.
4. Save the settings using START and press STOP
to exit the menu.
Setting the timer function of
the decorative lighting
TIME/DATE
The menu item
pairs of times per day at which the decorative lighting
is automatically switched on and off (e.g. Monday at
10:00 h on, at 12:00 h off, at 13.00 h on again, and
at 22:00 h off, Tuesday at 11:00 h on, at 22:00 h off,
etc.). If a switching time is not required, it can be
deleted by pressing 1.
TIMER
1. Invoke the menu.
2. Select the days of the week with START and then
press 5 (plus button) or 0 (minus button) to set the
desired day.
M a n u a l d e i n s t r u c c i o n e s | mon amie
PRESEL
.
menu.
allows you to enter two
25