Oil Pressure; Fuel Recommendations - Snapper 2691556, 2691663 Manual Del Operador

2. Stop the engine and remove the key. Make sure that the
oil fill area is clean.
3. Remove the dipstick (A, Figure 6). Remove the remaining
oil from the dipstick.
4. Install and tighten the dipstick.
5. Remove the dipstick again, and check the oil level.
6. Make sure that the oil level is at the top of the FULL mark
(B) on the dipstick.
7. If the oil level is FULL, install and tighten the dipstick.
8. If the oil level is LOW, add oil into the oil fill tube (C).
Note: DO NOT add oil at the quick oil drain (if equipped).
9. Wait one minute, and check the oil level again.
10. Install and tighten the dipstick.
10
6

Oil Pressure

If the oil pressure is too low, a pressure switch (if equipped)
will either stop the engine or activate a warning device on the
equipment. If this occurs, stop the engine and check the oil
level with the dipstick.
If the oil level is below the ADD mark, add oil until it touches
the FULL mark. Start the engine and check for the correct oil
pressure before you operate the machine.
If the oil level is between the ADD and FULL marks, DO NOT
start the engine. Contact an Authorized Service Dealer to
correct the oil pressure.

Fuel Recommendations

Fuel must meet these requirements: