Operations; Turning The Display On And Off; Adjusting The Volume And Input Source; Add A Label To An Input Source - Legamaster ETX Serie Manual Del Usuario

5. OPERATIONS

5.1. TURNING THE DISPLAY ON AND OFF

Turning the display on
1. Connect the e-screens AC-in socket to an AC power outlet using the supplied power cable.
2. Set the AC switch to „l". The screen is now in standby mode. Waint untill the status led lights up red.
3. Press the power button on the control pad, alternatively you can use can use the power button on the
remote control
Turning the e-screen off
With the Power on, press the power button on the control pad or remote control. A warning message will
appear. To turn off power completely, turn the AC switch to „O" or disconnect the AC power cord from the
power outlet.
Note:
If there is no signal input for a period of time, the e-screen will automatically go into power saving (sleep)
mode.

5.2. ADJUSTING THE VOLUME AND INPUT SOURCE

Adjusting the Volume
1. Using the remote or control panel, press the VOLUME- or VOLUME+ to increase or decrease the volume.
Selecting the input source
1. Press the SOURCE button on the control pad or on the remote control. The screen will display available sources.
2. Select a source by touching the icon displayed on screen. Alternatively, use the remotes directional buttons < >
to cycle through available sources and use the OK button to select a source.
3. If the e-screen cannot find a source, a "No signal" message will appear.

5.3. ADD A LABEL TO AN INPUT SOURCE

To indicate what type of equipment, device or connection is linked to an input, a label can be added. Please refer
to the Edit Input setting in the ‚Lock' menu in chapter 6.
OPERATIONS
ETX-SERIES – USER MANUAL – ENGLISH
13