Using Programs; Reading The Values Of A Program - Kinetec CPM concept Manual De Empleo

The KINETEC C.E.M. allows you to store up to 16 programs, including the type of movement, ROM, speed, load, pauses and timer.
The original parameter values of the program are empty.
These values can be modified and recorded at any time (see 'How to enter a program' page 9)
Beginning
To Stop the Unit
To access the program mode
To change the program if necessary
To exit and validate the selected program
To exit without validation of selected program
Start the unit
Beginning
To Stop the Unit
To access the program mode
To change the program if necessary
To read the speed value
After 5 seconds or after pressing on another key
To exit and validate the selected program
Start the unit
Comments:
• The values shown in the 'Display' column are examples. They actually depend on the stored programs.
• The current movement parameters can be changed while using that program but no data will be stored in the original program.
See the programming mode (page 9) to modify programs
Keys to press
Elbow module
10 STOP
Program
20 Ext/Flex
Program
or
-10 warm up
Warm up
-10 stop
ELBOW MODULE
10 STOP
Warm up
-10 STOP
Keys to press
ELBOW MODULE
-10 STOP
Program
-10 warm up
Program
or
50 Ext/Flex
Program
SPEED:
Elbow module
-10 STOP
Warm up
-10 STOP
Warm up
-10 RUN
Display
Check if the hand control is not locked
0 110
(See page6).
10
The program number blinks.
90
3
The new program number blinks.
130
The current parameters have been
0 130
recorded in program 3.
Back to the starting parameters.
0 110
The value change at the speed of the
0 130
movement.
Reading the values of a program: example SPEED
Display
Check if the hand control is not locked
0 50
(See page 6).
3
The program number blinks.
30
10
To change the program if necessary.
30
10
Displays the speed value.
2
0 50
The current parameters have been
0 130 recorded in program 3.
The value change at the speed of the
8 130
movement.
Use of the hand control

Using Programs

Remarks
Remarks
GB
11