How To Use The Warm Up Key - Kinetec CPM concept Manual De Empleo

Use of the hand control

How to use the WARM UP key?

Beginning
To stop the unit
To select the Warm Up mode
Start the movement
Warm Up rules:
The Kinetec C.E.M. starts at 70% of the full ROM, increasing 5% of the range every other cycle until the pre-set ROM is reached.
Comments:
- The parameters modification should always be done while the unit is stopped.
- Pauses and By-Pass mode are not available during warm up cycles.
- The Warm Up cycles are only working when the movement first begins.
- To start new Warm Up sessions press twice the « Warm Up » key.
- The calculation mode used enables reaching the pre-set ROM in approximately seven full cycles.
Example:
For a Warm Up treatment with a pre-set ROM from 100° to 0°.
The first cycle starts from 15° to 85° to 15° and increase 5% each cycle
GB
12
Keys to press
-10
-10
-10
100°
50°
0°
Display
ELBOW MODULE
STOP 15 50
Warm up
STOP 15 50
Warm up
RUN 20 50
Remarks
Check if the hand control is not locked
(See page 6).
The value change at the speed of the
movement.