Operation Testing; Testing Automatic Pump Operation - Little Giant 6 Serie Manual Del Proprietário

Ocultar thumbs Ver también para 6 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION TESTING

Risk of damage to pump or other equipment.
Do not attempt to run the pump without water; this could result in permanent damage to the pump.
If pump is run dry, it may damage pump and void the warranty.
If the pump does not operate properly, refer to
found, please contact the place of purchase or an authorized service center.
Do not let the unit run dry (without liquid). It is designed to be cooled by pumping fluid. The seal may be
damaged and the motor may fail if the pump is allowed to run dry.
If the unit is going to be idle for a period of time, follow the cleaning instructions in
Volute" on page
12. Do not let the unit freeze. This may cause cracking or distortion that may destroy the
unit.

Testing Automatic Pump Operation

Pump models 6-CIA, 6-CIA-RS, 8-CIA, and 8-CBA are equipped with a diaphragm switch that operates by
balancing water and air pressure. Rising water in the basin applies pressure to the diaphragm, which acti-
vates the switch, turning on the pump. As the water level falls, the pressure decreases until the switch deac-
tivates, turning off the pump. For the switch to function properly, it is vented to the atmosphere through a
breather tube routed through the pump's power cord. Non-restrictive air flow in the breather tube is
required.
Pump model 6-CIA-RFS is equipped with a remote float switch with a piggyback plug on the switch cord.
The pump must be plugged into the piggyback switch cord for automatic operation.
When the pump is installed in a basin with a sealed cover, pump operation cannot be observed. The basin
cover will usually have a spare hole that is plugged with a rubber plug. This plug can be removed and pump
operation can be observed.
To test system operation, follow these steps:
1.
Connect the pump to an appropriate power supply with voltage consistent with the pump voltage, as
indicated on the pump nameplate.
2. If there is a gate valve on the discharge line, be sure the valve is open.
3. Run water into the basin until the pump is activated. Do not attempt to run the pump without water;
this could result in permanent damage to the pump.
4. Confirm that the pump and its control switch are functioning as intended.
NOTE: If the pump doesn't turn on, test the switch. Refer to
or
"Testing the Float Switch" on page
5. Confirm that the ON/OFF levels are within specification, and confirm that no potential obstructions
exist that could inhibit switch operation.
6. Confirm that there are no leaks in the pump discharge plumbing and main home drain pipe plumbing.
NOTE: It is normal for a stream of water to spray from the air bleed hole in the pump's plumbing. Water
also sprays out of a hole in the base of the unit. Confirm that this spray is captured within the basin.
7.
Allow the pump to operate through several on/off cycles.
"Troubleshooting" on page
"Testing the Diaphragm Switch" on page 10
10.
Testing Automatic Pump Operation
13. If the solution still cannot be
"Cleaning Impeller and
OPERATION TESTING
9

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido