Maintenance; Light Bulb Replacement - Dimplex DF2608 Manual Del Propietário

Operation
on button located on the
remote control transmitter.
!
NOTE: You will have only 10
seconds to perform this last
step. Failure to do so will
result in these steps needing
to be followed again.
This will synchronize the remote
control transmitter and receiver.

Maintenance

WARNINg: Disconnect power
before attempting any
maintenance or cleaning to
reduce the risk of fire, electric
shock or damage to persons.

Light Bulb Replacement

Allow at least five (5) minutes
for the light bulbs to cool before
touching them to avoid accidental
burning of the skin. The light
bulbs need to be replaced when
you notice a dark section of
the flame or when the clarity
and detail of the log ember bed
exterior reduces. There are
three (3) bulbs under the Log Set
Assembly, which generate the
Figure 6
Button
Button
flames and embers, and two (2)
bulbs above that illuminate the log
exterior.
Lower Light Bulb Requirements
Quantity of three (3) clear chan-
delier or candelabra bulbs with an
E-12 (small) socket base, 60 Watt
rating. Example: GE 60BC or
Philips 60CTC.
Do not exceed 60 Watts per
bulb.
Helpful Hints
It is a good idea to replace all
light bulbs at one time if they are
close to the end of their rated life.
Group replacement will reduce
OFF
ON
Battery
Cover
13