Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
13. INSTALL THE POWER PACK
Take care not to kink ducting when installing the power pack.
Using provided no. 8 x 1/2" chrome plated screws, install the power pack inside
the custom hood. Start with 2 screws on front corners, then use 4 screws for
sides and use the remaining ones to finalize securing the front power pack. (See
figure beside for mounting screw specific locations.)
Make sure the adapter/damper (or the adapter) enters the ducting. When there
is access to the top of the power pack, seal connections with metal foil duct tape.
14. REINSTALL THE BLOWER(S)
CP34
CP35 M
AND
ODELS
Slide the blower to engage its flange in the
retaining bracket.
Using a 5/16" socket, secure the blower to
the inner top of the power pack with all blower
mounting screws (previously removed in
step 12).
CP37 M
ODEL
For each blower, slide it to engage its flanges in both retaining brackets.
NOTE: Both blowers are identical and can be mounted on either side of the power pack.
For each blower, using a 5/16" socket, secure the blower to the inner top of the power pack
through the front and rear brackets with all blower mounting screws (previously removed
in step 12).
CAUTION
HD0293
L
S
M
EFT
IDE
OUNTING
S
L
CREW
OCATION
HD0269
- 9 -
HH0102A
R
S
IGHT
IDE
M
S
OUNTING
CREW
L
OCATION
HD0282
HD0298
B
F
LOWERS
RONT
B
R
LOWERS
HD0297
B
RACKET
B
EAR
RACKET
Publicidad
Tabla de contenido
