Health O Meter 1100KL Instrucciones De Uso página 8

1100KL ASSEMBLY INSTRUCTIONS (CONTINUED)
14. Place the pivot bracket screw covers over the pivot screws. Fasten the covers to the back of
the display using (4) Phillips pan head M4 screws (D). Use Phillips head screwdriver to tighten
the screws (see Figures 1 & 5 on pages 9 & 10).
15. Attach the adapter holder to the center rail using (2) #8 x ½ sheet metal screws (C). Use
Phillips head screwdriver to tighten the screws (see Figures 1 & 2 on page 9).
16. Connect the AC adapter to the power port in the display. Do not plug the scale into a power
source until the scale is fully assembled (see Figure 6 on page 11).
17. Attach the front and rear display support covers, applying light pressure to snap these covers
into place (see Figure 2 on page 9).
18. The scale is now assembled. Plug the AC adapter into a power source and / or insert
batteries.
8