Vetus HTP20RT Instrucciones De Instalación página 4

Introduction
This manual relates to Vetus steering pumps, types HTP20RT, HTP30RT and HTP42RT.
This manual is a supplement to the manual supplied with the cylinder. (2.0105 I.H30-175,
or 2.0113 I.OB300)
Note:
The Vetus EHP type 'R' is already equipped with a built-in check valve.
Fitting
Steering pump
The filler cap and balance tube* must always be on top of the unit, at the highest point.
*) When more than one pump is fitted, all oil reservoirs must be connected by balance
tubes.
The pump may be installed in any position
between horizontal and vertical.
90˚
Fit the steering pump using the bolts provided.
The steering pump is supplied with a filler cap without air holes as standard. If necessary,
this can be replaced by the filler capwith air holes also supplied.
With double operation, check that the lowest steering pump is fitted with a filler cap with-
out a hole.
4
2.0117
Steering pumps HTP20RT, HTP30RT, HTP42RT
www.busse-yachtshop.de | info@busse-yachtshop.de