Dispensing Coffee; Preparing The Filter Holder; Dispensing - Aep Version; Dispensing - Sae Version - Astoria Core200 AEP Manual De Uso Y Mantenimiento

Core200

6.7 Dispensing coffee

Preparing the filter holder

6.7.1
Before filling the filter holder, make sure it is emp-
ty and any previous coffee residue has been re-
moved.
• Fill the filter with a dose of ground coffee (approx. 6-7 g);
follow the procedures specified by the manufacturer of
the grinder-dispenser.
• Compress the coffee with the special press.
• Clean the rim of the ground coffee filter before attaching
the filter holder to the dispensing group.
• Hook the filter holder to the group without closing it too
tightly in order to prevent the gasket from wearing quickly.

Dispensing - AEP version

6.7.2
• Place the coffee cup under the dispensing spout.
• Press the desired dispensing switch (1): the coffee
will begin being dispensed, and it can be stopped
via the same switch once the desired amount of
coffee has been obtained in the cup.
6.7.3

Dispensing - SAE version

Do not remove the filter holder from the dispens-
ing group when coffee is being dispensed.
Do not insert your fingers or any other objects
into the filter holder.
• Put the coffee cup under the dis-
pensing spout
• Press the desired dose button (e.g.
) and wait for the coffee to finish
being dispensed.
• To stop coffee dispensing ahead of
time, press the button again.
• Use the manual dispensing button
should the pushbutton panel
malfunction or to continuously
dispense coffee.
38 160
of
When using small-sized cups, a specific raised cup
grille (20) is available.
The display (16) beneath each keypad will count
the duration of the dispensing cycle
in seconds.
1

Programming coffee doses

6.7.4
Each dose must be programmed with freshly
ground coffee and not with previously-used coffee
grounds. The system will automatically exit the
programming mode 20 seconds after the last action was
carried out.
Do not remove the filter holder from the dispens-
ing group when coffee is being dispensed.
Do not insert your fingers or any other objects
into the filter holder.
• Always programme the right pushbutton panel first. This
way, all the pushbutton panels will be automatically pro-
grammed. If necessary, subsequently programme the
others.
• Place the cup under the dispensing
spout.
• Press and hold the
at least 5 seconds until the same
button starts to flash.
• Press the desired dose button, for
example
• To confirm the dose, press the
button again or the
button for
.
button.
20
0 5
User manual