Pre-Set Values; Dispensing Via The Steam Nozzle - Astoria Core200 AEP Manual De Uso Y Mantenimiento

• Repeat this operation for the other
dose buttons.
• When you have finished program-
ming, press the button or wait
20 seconds.
6.7.5

Pre-set values

Use this procedure to reset the factory values for the coffee
beverage doses.
Proceed as follows:
• Turn the machine off.
• Restart the machine by pressing and holding the
and buttons on the right pushbutton panel.
• Only release the buttons when the
flashing on all the pushbutton panels.
• Switch the machine off and back on again.
User manual

6.8 Dispensing via the steam nozzle

parts of the body. Do not touch the steam nozzles with bare
hands; use the appropriate PPE.
• Immerse the steam nozzle (5) into
the liquid to be heated.
• Rotate the valve knob (14) anti-
clockwise.
,
• The quantity of steam will be pro-
button LEDs are
portional to how open the valve is.
• To stop dispensing, turn the valve
knob (14) clockwise.
To optimally froth the milk, follow these simple rules:
• Only heat the amount of milk that you intend to use;
once heated, it will have to be completely poured out of
the jug and cannot be reheated.
• Froth the milk which should be at a temperature of
around 4°C.
all times using a cloth dampened in lukewarm water. Only
leave the steam nozzle immersed in the milk for the time
needed to heat it.
pipes.
Carefully move the steam nozzle using the specific
anti-scald rubber grip (6).
Do not direct the steam towards hands or other
Before using the steam nozzle, the condensation
draining operation must always be carried out for
at least 2 seconds.
To keep the steam nozzle tips in perfect working
order, it is advisable to carry out a brief dry dis-
pensing run after each use. Keep the tips clean at
Do not open the steam valve with the automatic
steam wand immersed in milk and the machine
switched off, as the latter would suck milk into the
Core200
5
14
6
5
14
39 160
of