1.0 INTRODUCTION
This booklet describes the regulations for use, maintenance for
seeding machine. This booklet is an integrating part of the
product, and must be kept in a safe place for consultation during
the whole life span of the machine.
The equipment described in these instructions for use complies
with current safety provisions and the current state of the art and
technology. However, should the equipment be used in an improper
manner, the risk of injury occurring cannot be totally excluded. For
this reason, the following pages contain warning messages, marked
with the following symbol:
1.1 DESCRIPTION OF THE EQUIPMENT
This particular machine is ideal for not-tilled ground, stubbly ground
and for the mechanical control of weeds.
The refining and levelling action is carried out by two rows of curved
discs and a rear compacting roller. The cultivators may be used for
ploughing purposes, in order to break up the land leaving residues
and organic substances in the layers nearer the surface, thereby
promoting soil fertility.
Usually, the machine is immediately ready for use. We do, however,
recommend checking that the screws, bolts and hydraulic con-
nections are well-tightened before use and after approx.15 hours
of operation. The highest admissible speed of the machine is 25
km/h. Such speed should, however, be greatly reduced when the
ground is uneven. Excessive speed causes high dynamic stress
which reduces the life span of the machine. If the machinery is being
used on public roads or streets, the cultivator must be equipped
in conformity with the provisions laid down by the Highway Code
in force. In particular, it should be equipped with suitable lighting
and signposting.
ATTENTION
The equipment has been designed exclusively for the cultiva-
tion of stubbly ground or for the preparation of seedbeds on
low-tillage land. Any other use different from that described
in these instructions could cause damage to the machine and
represent a serious hazard for the user.
Regular operation depends on the correct use and adequate main-
tenance of the equipment. It is advisable therefore to observe scru-
pulously what is described in order to prevent any inconveniences
cod. F07011424
ENGLISH
that could prejudicate proper operation and duration. Additionally,
all the information required to ensure the best use of the machine is
provided, together with instructions and useful advice for its correct
maintenance. It is just as important to keep to what is described in
this booklet since the Manufacturer declines all responsibility
due to negligence and non-observance of these rules.
At any rate the Manufacturer is available to assure immediate and
accurate technical assistance and all that may be necessary for
the improved operation and better performance of the equipment.
1.2 GUARANTEE
-
On delivery, check that the equipment has not been damaged
during transport and that the accessories are integral and
complete.
-
Possible claims must be presented in writing within eight
days of receipt.
-
The purchaser will enforce his rights on the guarantee only
when he has respected the conditions concerning the benefit
of the guarantee, set out in the supply contract.
-
The guarantee is valid for 1 year, against all defects of material,
from the date of delivery of the equipment.
-
The guarantee does not include working and shipping costs
(the material is shipped at the consignee's own risk).
-
Obviously, all damage to persons or things are excluded from
the guarantee.
-
The guarantee is limited to the repair or replacement of the
defective piece, according to the instructions of the Manufac-
turer.
Dealers or users may not claim any indemnity from the Manufac-
turer for any damage they may suffer (costs for labor, transport,
defective workmanship, direct or indirect accidents, loss of earnings
on the harvest, etc.).
1.2.1 EXPIRY OF GUARANTEE
Besides what has already been set out in the supply contract,
the guarantee expires:
-
If the limits set out in the technical data table are overshot.
-
If the instructions set out in this booklet have not been carefully
followed.
-
If the equipment is used badly, defective maintenance or other
errors by the client
-
If modifications have been carried out without written authori-
zation of the manufacturer and if non original spare parts have
been used.
23